View Single Post
Old 02-05-2017, 06:08 PM   #8
Clifford
Member
 
Join Date: Oct 2012
Posts: 86
Default

Update.

Auto safeties can get annoying and although the updated safety is an improvement you also can't decock the rifle. The guys over on TAG found a way to get the best of both worlds.

http://www.talonairgun.com/forum/vie...hp?f=4&t=27098

The dowel is not needed for this modification. I used the punch I had on hand for the pin the manipulate the hammer just enough to get the little tab to fall out. They are directional pins so take a look at the pin before you hammer it back in. The only reason it mentions lowering the power wheel down is to avoid excessive hammer spring tension when you go to decock the rifle. My power wheel was set at 2-12 and I left it there. Just be prepared for whatever tension you have it set at and you should be fine.


This one only take a couple minutes to do and is well worth it.

Last edited by Clifford; 02-05-2017 at 06:11 PM..
Clifford is offline   Reply With Quote