View Single Post
Old 01-18-2013, 10:44 PM   #2
Clifford
Member
 
Join Date: Oct 2012
Posts: 86
Default

Begin by removing the stock. one screw holds it together; don't worry about the trigger guard.



There are four screws that hold the end cap on. For reference the book also has an exploded view, I just posted both links in case one worked better for some than the other.

Start by removing the two screws located at the rear of the breech (part #6). Dont worry the end cap won't fly off just yet.



Then you'll want to remove the two recessed screws on either side of the air tube (part #16)



Remove one screw and begin to hold the end cap





Once you take the second screw out the end cap will be at the mercy of the spring so let the pressure off slow. Don't worry, there's not a lot of pressure here, just make sure your holding it.

Last edited by Clifford; 01-18-2013 at 10:55 PM..
Clifford is offline   Reply With Quote