View Single Post
Old 07-16-2017, 10:06 PM   #5
Badmoets
Member
 
Join Date: Feb 2016
Location: Fryslan, the Netherlands
Posts: 52
Default

Hiya,

with the latest hammer the cocking of the gun goes easier. like it oughta. I did some testing yesterday, i shoved a pellet through the barrel. It was obvious some lead scraped off of the pellet. Close inspection made clear that there was a tiny sharp edge around the transferport in the barrel.


This afternoon i spent some time getting that sharp edge out of the barrel. Waterproof sanding paper and some oil did the trick. When i shoved another pellet through the barrel i found out that with the 25 grain pellets the barrel is a bit wide, a bit too large in diameter so to say. The klands and grooves leave hardly any impression on the pellet.


I`ve been mailing with Krale, he`s the importer of Kral and he asked me to bring the gun back to his shop. He offered me to see if thare is a better barrel for the gun. I told him earlier that there was no warranty anymore for i bought the gun second hand and i`ve been working on the gun pretty much. He told me he didn`t mind.

I`ll see if i cabn find the time to go the Krale. I`ll keep ya guys posted.

Best, Roel
Badmoets is offline   Reply With Quote